Deck permits in
Roy.
Roy names decks in its own list of permit work, and its snow load is 40 psf — not the valley's 28.
Do you need a permit to build a deck in Roy?
Yes, and Roy says so by name. The city’s permit rule lists the work that requires a permit and includes decks explicitly, alongside basements, additions, hot tubs, pools and mechanical changes. Roy also publishes a Residential Deck Permit Information handout. Permits and inspection requests go through roycity.mycityinspector.com.
Source: Roy City Building Permits & Inspections — Design Criteria. Read from the city’s own document and verified .
The numbers your drawings have to use
These come straight from the city’s published design criteria. They are what a plan reviewer checks a deck against.
| Criterion | Value |
|---|---|
| Ground snow load | 40 psf |
| Frost depth | 30 inches below grade |
| Wind speed | 120 mph, Exposure B or C |
| Seismic design | D0 |
| Codes | State-amended 2021 IBC, IRC, IPC, IMC, IFGC; 2020 NEC |
| Portal | roycity.mycityinspector.com |
Roy sits between two worlds and its numbers show it. The 40 psf snow load is well above Salt Lake County’s 28 and below Ogden’s 43–50 — Weber County weather without the bench. But the seismic category is D0, which is lower than the D2 used across most of the valley and lower than Ogden’s D through F. That combination is unusual: heavier snow, lighter seismic.
Roy lists a deck as permit work in plain words
Most cities leave you to work out whether a deck is covered. Roy writes it into the permit rule directly: the completion or finish of any basement, addition, hot tub, deck, pool, air conditioner, water heater change, furnace and any added electrical, plumbing or heating requires a permit.
There is no square-footage carve-out stated in that sentence, so do not assume the 200 sq ft code exemption survives it without asking. Roy also publishes a deck-specific handout — ask for it, because the copy on the city site is a scanned document and does not read well on a phone.
Do not carry a valley seismic detail here, and do not carry a Roy one south
Roy’s D0 is a materially lighter seismic category than the D2 used in Salt Lake City, West Jordan and Taylorsville. A ledger and lateral detail engineered for Roy is not adequate in the valley.
It cuts the other way too: a deck detail from Roy taken to Ogden, ten minutes north, lands in a city that states categories D, E and F all exist and requires a soils study.
Who to talk to at the city
Roy City Community Development, 5051 South 1900 West, Roy, UT 84067. Phone 801-774-1040 · Building Permits & Inspections. Apply and request inspections at roycity.mycityinspector.com.
40 psf is not 28 psf. Roy is twenty-five minutes from the north end of Salt Lake County and carries roughly forty percent more snow load. Joist spans and beam sizes that pass in Taylorsville do not automatically pass here.
We handle this part
Framing sized to Roy’s 40 psf, footings to 30 inches, the deck handout obtained from the city rather than guessed at, MyCityInspector submittal and inspections — in our quote, not an extra.
