Deck permits in
Ogden.
Ogden's snow load is roughly double Salt Lake City's. A deck designed for the valley does not work here.
Do you need a permit to build a deck in Ogden?
Yes — and the design is not the same as a valley deck. Ogden publishes a ground snow load of 43–50 psf against Salt Lake City’s 28 psf minimum, so beams, joists and posts all size up. A deck is exempt from a permit only under the full IRC §105.2 exemption: free-standing, 200 sq ft or less, floor under 30″ above grade, unattached and not serving an exit door.
Source: Ogden City Design Criteria, Building Permits & Inspections. Read from the city’s own document and verified .
The numbers your drawings have to use
These come straight from the city’s published design criteria. They are what a plan reviewer checks a deck against.
| Criterion | Value |
|---|---|
| Ground snow load | 43–50 psf, per Utah Statewide Amendments Table R301.2(5a)/(5b) |
| Frost line depth | 30 inches below grade |
| Wind speed | 115 or 120 mph, 3-second gust, Exposure B or C |
| Wind topographic effects | None |
| Seismic design | Categories D, E and F all exist in Ogden — soils study required |
| Weathering | Severe |
| Winter design temperature | 5°F |
| Air freezing index | 868 |
| Mean annual temperature | 51.4°F |
The snow number is the headline. 43 to 50 psf is between one and a half and nearly two times what a Salt Lake County design assumes, and it is the single most common reason a deck detail carried north from the valley fails plan review. It comes from the Utah Statewide Amendments to the IRC, Table R301.2(5a) and (5b), with site values available from the USU map.
Ogden is the one city on our list where seismic forces a soils report
Ogden states plainly that seismic design categories D, E and F all exist within the city, and that a geotechnical soils study is required. Categories E and F are the highest in residential practice, and they exist here because of the Wasatch fault and the soils along it.
For a deck this is not academic. It drives lateral connections, the ledger detail where the deck meets the house, and in some cases whether the deck is allowed to be attached at all rather than free-standing.
Wind is given as a range, not a number
Ogden lists 115 or 120 mph at Exposure B or C — meaning it depends where in the city you are. Topographic effects are listed as none, which is one thing that makes it simpler than Provo.
Because both the speed and the exposure vary, this is a value to confirm for the address rather than assume. The difference between B and C on a roofed deck is real.
Who to talk to at the city
Ogden City Building Permits & Inspections, 2549 Washington Blvd, Ogden, UT 84401. Phone 801-629-8000 · design criteria. The city publishes its codes, fees, permit applications and submittal process on the same site.
Never carry a Salt Lake County deck design into Ogden unchanged. The frost depth matches at 30 inches, which makes it look familiar, but the snow load is 43–50 psf against 28, and seismic can be two categories higher. Those are not tweaks; they change member sizes and connections.
We handle this part
Sizing to Ogden’s real snow load, the soils study where seismic demands it, the ledger and lateral detail that category E and F work needs, drawings, submission and inspections — in our quote, not an extra.
